Secure Checkout
Free Ground Shipping On All Domestic Orders Over $59
Your Shopping Cart Is Empty

Secure Checkout

SKU: 23277 Stairway To Heaven Short Black

Stairway To Heaven Short Black
Purchase Stairway To Heaven Short Black
  • SKU: 23277 Stairway To Heaven Short Black

  • $39.95

    Shipping Weight: 0.25 pounds

    Quantity in Basket:  None

  • Sign up with your email to be notified when this product is back in stock!


This popular electrode design has now evolved into three lengths to cater to all stimmers.

It draws inspiration from my holy plate electrode design that was created to act as a sort of splint to help growers and shrinkers not have to worry about their shaft electrodes coming into contact with each other.

So here is Short Stairway To Heaven, and it allows you to place the two front loops in any of the three holes in the ABS body of this electrode holder. It also features a splint on the lower side of the front loops to help to prevent the loops from touching and shorting out.

My suggestion would be to use the two outer loops on one channel to stim the Dorsal and Perineal nerve groups.

It's recommend using the middle loop in conjunction with the tip of an anal electrode. Something like the Moaner or Large Flo would be perfect, but even a monopole pad electrode placed behind your anus would work well too.

This electrode holder is made from ABS (think Lego plastic); it's hard-wearing, non-porous and doesn't need painting or any other finish. The post-print processing time to get the smooth, non-porous finish takes me a long time, and this is reflected in the price. If you prefer the best, then this is the version for you. They will be available in very limited quantities, so grab one while you can.

This cock loop holder is printed in ABS. This holder has three generous lengths of 6mm conductive rubber tubing that can be trimmed to suit your anatomy. The high-quality British CR takes a 2mm plug.

It will be dispatched with the three 6mm conductive rubber tubing loops already fitted.


  • 1 x 33cm/13" Base Loop.
  •  2 x 25cm/10" Shaft Loops.

Care Instructions


This product is 3D printed in ABS, a very strong plastic with excellent mechanical properties. Once printed I post-process the components using a procedure called vapour smoothing. This uses Acetone vapour to melt and smooth the surface of the prints turning them from rough prints into smooth, shiny prints that are non-porous.

Porosity is one drawback of the 3D printing process as it leaves microscopic holes in the surface of prints that are perfect for bacteria to grow in and hard to clean. Vapour smoothing prints seals these tiny holes and imperfections, leaving the products smooth and sealed.

This is important as it makes cleaning post-play so much easier.

Product Care

After play, simply wash in warm soapy water. Anti-bacterial soap is best. Once body fluids have been washed off, allow the electrode to dry thoroughly before you store it away for later use.

A deep clean can be carried out using Isopropyl Alcohol, and this will kill bacteria and remove body oils.

Never use silicone-based lubes with conductive rubber-based electrodes as the silicone will bond to the conductive rubber, effectively destroying it and insulating it.

How To Use

  • Just slip it over your cock and tighten it before plugging your 2mm plug into the CR.