Filters

Secure Checkout
Free Ground Shipping On All Domestic Orders Over $59
Your Shopping Cart Is Empty

Secure Checkout

SKU: 23283 Estim Penis Play conductive 6mm Rubber Cock Loop with Insulator 2mm Plug Black


Estim Penis Play conductive 6mm Rubber Cock Loop with Insulator 2mm Plug Black
Purchase Estim Penis Play conductive 6mm Rubber Cock Loop with Insulator 2mm Plug Black
  • SKU: 23283 Estim Penis Play conductive 6mm Rubber Cock Loop with Insulator 2mm Plug Black

  • $29.95

    Shipping Weight: 0.20 pounds

    Quantity in Basket:  None

  • Sign up with your email to be notified when this product is back in stock!

Description

This electrode insulator is made from ABS (think Lego plastic), it's hard wearing, non-porous and doesn't need painting or any other finish. If you prefer the best then this is the version for you. They will be available in very limited quantities so grab one while you can.

When using conductive rubber cock loops for stimming you generally only stimulate the dorsal nerves running along the top of the penis. The sensations generated are felt at the glans of the penis. Insulating the top part of a lower cock loop if it is around the cock and balls allows you to stim both the Dorsal and Perineal nerves leading to a better sensations.



This cock loop insulator is be printed in my BLACK ABS. This insulator comes with 10"/25cm of 6mm conductive rubber tubing that takes 2mm plug.

It will be dispatched with the 6mm conductive rubber tubing already fitted.

The inner hole size is 1mm larger than the CR tubing, this 6mm tubing is a good friction fit and you don't need the plastic locking clamp to keep it in place once fitted. Just slip it over your cock and tighten before plugging your 2mm plug into the CR.

Dimensions

  • Inner Diameter: 1.5"/3.8cm
  • Hole Diameter: 7mm

Care Instructions

Material

This product is 3D printed in ABS, a very strong plastic with excellent mechanical properties. Once printed I post-process the components using a procedure called vapour smoothing. This uses Acetone vapour to melt and smooth the surface of the prints turning them from rough prints into smooth, shiny prints that are non-porous.

Porosity is one drawback of the 3D printing process as it leaves microscopic holes in the surface of prints that are perfect for bacteria to grow in and hard to clean. Vapour smoothing prints seals these tiny holes and imperfections, leaving the products smooth and sealed.

This is important as it makes cleaning post-play so much easier.

Product Care

After play, simply wash in warm soapy water. Anti-bacterial soap is best. Once body fluids have been washed off, allow the electrode to dry thoroughly before you store it away for later use.

A deep clean can be carried out using Isopropyl Alcohol, and this will kill bacteria and remove body oils.

Never use silicone-based lubes with conductive rubber-based electrodes as the silicone will bond to the conductive rubber, effectively destroying it and insulating it.

How To Use

  1. Place the insulated cock loop around your cock and balls with the plastic insulator on top. Use electrolube to ensure you get good contact between the conductive rubber and your skin.
  2. Attach a plug to one end of the conductive rubber.
  3. For the second electrode, I recommend either a cock loop of self-adhesive monopole pad electrode. Place the electrode either on your glans or just under it.
  4. Attach the second plug to the other electrode.
  5. Plug your cable into your control box and ensure all power levels knobs are set to zero output.
  6. Turn on your power box, select your favourite settings and slowly turn up the power.